IC-9100 Transceiver for Shortwave + VHF + UHF, Allmode + Satellite

The IC-9100 combines Icom experiences of many years in one radio. The shortwave receiver has inherited many features of the top radios: selectable roofing filters, doble super heterodyne receiver, IF DSP, two separate receivers and much more. Plus the well renowned tradition of Icoms V/UHF radios - now all in one radio.

Two independant receivers allow operation on two different bands, for example on shortwave + VHF or UHF, or VHF + UHF. In front of the first IF stage up to three selectable roofing filters reduce the bandwidth offered to the next stage. A 15kHz roofing filter comes installed, optionally a 6kHz or 3kHz filter can be installed. Especially the narrow filters enhance selectivity on HF and 50MHz. Each receiver has it's own DSP which supports functions like IF filtering, notch filters, AGC control,pas band tuning, noise reduction and much more.

The transmitter offers a full power of 100W on HF, 50MHz and 144MHz, 75W on 430MHz and 10W on 23cm with the optional 23cm module. An automatic antenna tuner for HF/50MHz is built in. The UT-121 D-Star option open the world of state of the art digital modulation on VHF an UHF, but also available on 28 and 50MHz. Together with the D-Star module comes the possibility to receive distance and position information from remote stations. Your own position is received by an optional GPS antenna or can be entered manually.

Also for the communication to the external world Icom uses well-proven and state of the art technology: the CI-V CAT interface, in use since more than 20 years is still available as well as a powerful USB socket. This USB socket offers not only CAT and remote control functions but also an audio interface. This turns the radio into a modem, it act's as an external soundcard to the computer. No more interface hassle required to get started with all computer-based modes! To decode RTTY you don't even need a computer at all, the IC-9100 does this internally.

Here you will find a preliminary datasheet of the IC-9100 (PDF, english).

[1]: Operation on 23cm requires the optional UX-9100 module
[2]: D-Star operation requires the optional UT-121 module
[3]: 15kHz Roofing filter installed, 6kHz and 3kHz optional
Order No.
IC-9100 HF/50MHz/VHF/UHF Transceiver Bel of mail

 

Accessories IC-9100

 

The IC-9100 accepts most known accessories by Icom and other suppliers. The transceiver has a 13-pin ACC socket, just like the IC-706, IC-7000, IC-7200 and IC-718.

Order No.
UX-9100 23cm Modul for IC-9100  
CS-9100 Cloning/Control Software for IC-9100  
MB-123 Carrying Handle  
OPC-1529R Serial Remote Control cable  
UT-121 D-Star Unit  
FL-430 Roofing filter 6kHz 1. ZF IC-9100 Bel of mail
FL-431 Roofing filter 3kHz 1. ZF IC-9100  
SM-30 Desktop microphone  
SM-50 Desktop microphone  
42920.13 13-pin DIN connector  
40105.070 1m cable, one side 13-pin DIN connector, other side open  
WCS-9100 Programming Kit  
PS-126 25A switching power supply from ICOM  

 

Icom RS-BA1 Remote Control Software

This transceiver can be operated remotely over the internet or a local network, using the RS-BA1 software.


Order No.
RS-BA1 Remote Control Software Bel of mail
RC-28 Remote Control Unit  


Frequency Extension for Radios

Please note:
All radios supplied normally cover only the amateur bands (transmit wise).

The frequency extension of a radio (TX open) is done on explicit request by the customer.

Amateur Radio transceivers are usually not specified for use outside the amateur bands. In some cases the radio and especially the final amplifier or output filters can be damaged when transmitting outside the amateur bands. These damages are not covered by any warranty.

The manufacturer warranty might be voided in some cases as well.

 

Alle prijzen zijn inclusief BTW., maar exclusief verzendkosten.
Tussentijdse prijswijzigingen en typefouten voorbehouden.
Fabrikanten kunnen specificaties en uitvoeringen wijzigen.