DR-1XE FM/C4FM relay 2m / 70cm

Yaesu offers you the dual mode repeater DR-1XE for a smooth transition from traditional FM mode to digital C4FM modulation. This relay is capable of both operation modes, the automatic mode select (AMS) recognizes the signal as C4FM digital or conventional FM and then the DR-1XE repeater retransmits the signal using the preset communications mode. This makes operating in FM as well as C4FM with only one relay possible.

The DR-1XE relay is shipped as a professional 19" system, an extrnal power supply (13.8V, 15A) is required. The repeater can be used either on 2m (144-146MHz) or 70cm (430-440MHz). Programming is done very comfortably via a large, coloured touch display on the front. With that you can program 'Id' (call sign), transmission and receiving frequency, transmission power (5, 20 or 50W), CTCSS, squelch and the automatic modulation select (AMS). Frequencies can be adjusted in 5 or 6.25kHz steps.

The device requires 13.8V, max. 15A for operation. The DC cable is included. The repeater has an internal loudspeaker for local checking, also a microphone can be plugged in for testing the transmitter.

The DR-1XE repeater has no diplexer built-in, but needs be added externally. On the rear side there are separate connectors for transmission and receiving antenna available. The transmission power can be adjusted to 5, 20 or 50W. The relay identifier can be transmitted via voice or CW output in adjustable time intervals to meet regulatory requirements for automatic operating units.

 


 

 

 

Technical Data DR-1XE
Function Value
Frequency 144-146MHz, 430-440MHz
Channel Steps 5/6.25kHz
Antenna Impedance 50 Ω
Power Supply 13.8V, max. 15A
Power Consumption 1.5 A (Receive)
13 A (50 W TX, 144 MHz band)
14 A (50 W TX, 430 MHz band)
Operating Temperature -20°C to +60°C
Size 483mm × 89mm × 38mm (B×H×T)
Weight 10 kg
Transmitter
TX Power 10/20/50 W
Antenna Connector N female
Modulation F1D, F2D, F3E
Reactance modulation F7W 4FSK (C4FM)
Spurious Emissions < 60 dBc
Frequency Stability ±2.5 ppm (-20°C to +60°C)
Receiver
Type Double Super Heterodyne
Intermediate Frequencies 1st: 47.25 MHz, 2nd: 450 kHz
RX Sensitivity 0.3 µV (Digital 2 m/70 cm) BER 1%
0.2 µV (FM 2 m/70 cm) 12dB SINAD
Antenna Connector N female
Neighbour Channel Supression < 65 dBc (typ., 20 kHz offset)
Channel Selectivity FM 12 kHz/35 kHz (-6 dB/-60 dB)
Intermodulation < 65 dB (typ., 20 / 40 kHz offset)
Audio Output 4 W (4 Ω, THD 10%, 13.8 V; internal speaker)

 

HRI-200 Internet Link Adapter

 

With the HRI-200 the Yaesu C4FM-Devices like the FTM-400 or the DR-1 can be connected to the internet. The required software and the device cables are in included. The HRI-200 can control 2 Transceiver at the same time and watch on 4 frequencies.
The HRI-200 interface supports the full functionality of Wires-X as the networking of the Group Monitor, Local Info, emergency ...
Even on older devices, the HRI-200 can be used. Here the interface is then operated only in FM mode and controlled via DTMF. The features are significantly limited.

The connection between the HRI-200 and a computer is performed only by the supplied USB cable. An additional power supply, etc. is not necessary. The necessary router configuration, the software can make by UPnP in the router itself.


 

Alle prijzen zijn inclusief BTW., maar exclusief verzendkosten.
Tussentijdse prijswijzigingen en typefouten voorbehouden.
Fabrikanten kunnen specificaties en uitvoeringen wijzigen.