IC-7410 HF/50MHz All mode Transceiver

IC-7410Faster DSP unit and in-house DSP expertise
Icom brings out the best DSP performance combining more than ten years of DSP technical know-how and much faster DSP processors. Icom’s in-house DSP experts have developed a IC-7400 replacement that every operator will be proud to own. In addition to the higher speed DSP, the AD/DA converter, AK4620B, provides a higher dynamic range and superior S/N ratio.

Double-conversion superheterodyne
Introduced with the IC-7800, a double conversion superheterodyne design, with an image rejection mixer for the 2nd mixer stage is employed in the IC-7410. This receiver design not only reduces the electronic complexity, it greatly reduces the number of internal distortion points from older triple and quadruple conversion receivers.

+30dBm third-order intercept point (IP3)

In Icom’s continuing efforts to create the best receiver, the design of the IC-7410 incorporates the latest in DSP software technology and Icom’s analog RF circuit experience for a +30dBm* IP3, rivaling the IC-7600. The end result, clear reception of weak signals surrounded by QRM from broadcast and neighboring ham stations.  * In 14MHz band.

Three first IF filters (3/6/15kHz)

Optional 1st IF filters (6kHz, 3kHz) The IC-7410 accommodates three 1st IF filters with the 15kHz, 1st IF filter supplied, while the 3kHz FL-431 and 6kHz FL-430 are optional for better
receiver performance by protecting the desired signal from nearby strong signals.
(Fixed for 15kHz in FM mode.)

Large, multi-function LCD
The display increases in width from the IC-7400. The large multi-function LCD shows frequency, 9-character channel name, channel number, multi-functional meter (includes S-meter, RF output, SWR, ALC and COMP level).
The dot-matrix portion of the LCD shows the following items:

USB connector for PC control

The IC-7410 has a standard type B USB connector and can be connected to a PC. Modulation input, audio output, RTTY demodulator output and CI-V command can be controlled via the USB cable. Also, the conventional CI-V remote control jack is built in to the IC-7410.

RTTY demodulator and decoder
The built-in RTTY demodulator and decoder allow you to instantly read an RTTY message on the display. No external units or PC required. The built-in tuning indicator visually helps in critical tuning.

Simple band scope
The built-in simple band scope shows the band condition at a glance and is handy for searching for active stations.

Wide range of DSP features
Using the latest algorithms, the digital features give flexibility and speed needed for working in tough RF conditions.

Ample CW functions
All of the following CW capabilities are included in the IC-7410:

High frequency stability
A high stability TCXO crystal oscillator provides ±0.5ppm of high frequency stability over a wide temperature range (0°C to +50°C). This allows for a long steady operating time in digital modes.

Large heat sink

IC-7410 chassis When compared to the IC-7400, the IC-7410’s large heat sink improves heat dissipation. Even during long hours of heavyduty cycle operation, the IC-7410 provides stable output power.

Other features

Optional RS-BA1 IP remote control software

The optional RS-BA1 software allows you to use the IC-7410 from another room using your home network or even from a remote location over the Internet.

Rear Panel View


Order No.
IC-7410   Bel of mail

Alle prijzen zijn inclusief BTW., maar exclusief verzendkosten.
Tussentijdse prijswijzigingen en typefouten voorbehouden.
Fabrikanten kunnen specificaties en uitvoeringen wijzigen.